Apps & launchersReviewed
Box Shows "Copying Log" at Every Start: Turn It Off
A 'copying log' message at every boot slows your Carlinkit TBox start-up. Turn off Automatic log copy in the box's settings. TBox Ultra 3 and Ambient.
Carlinkit TBox Ultra 3Carlinkit TBox Ambient
Quick answer
On the Carlinkit TBox Ultra 3 and Ambient, the 'copying log' message that appears at every start and slows the boot stops once you turn off Automatic log copy in the box's settings. Two owners confirmed it. On the Ultra the option sits under Other; on the Ambient it moved in the 15 Oct 2024 build.
Symptoms
- A 'copying log' message appears at the bottom of the screen every time the box starts
- The box takes an extra minute or two to finish starting up
- It happens while a microSD or USB flash card is left in the box
- Nothing responds normally during those first couple of minutes
Applies to
- Connection to the car
- CarPlay and Android Auto
- Firmware in confirmed reports
- Carlinkit TBox Ambient: 2024-10-15
- Highest risk on this page
- Low risk
- Status
- Workaround confirmed by the community
Why it happens
These boxes can copy their internal log to an inserted memory card. When that option is on, the box writes the log to the card every time it powers up.
On some firmware the copy runs before the rest of the system is ready, so the screen shows “copying log” at the bottom and the start-up stalls for a minute or two. Nothing else starts normally while it runs.
The log is written to whatever card is in the box, so taking the card out also stops the message — but then you lose the card’s storage. Turning the option off keeps the card and stops the copy.
Fixes, ranked
Turn off Automatic log copy in the box's settings
- Low risk
- Time: 5 minutes
- Worked for 2 of 2 reports
- Open the box’s Settings.
- On the TBox Ultra, go to Other → Automatic log copy. On the Ambient 6225 build from 15 Oct 2024 this option moved, so look through the settings list until you find Automatic log copy; if you are not sure which build you have, see which TBox do I have.
- Turn Automatic log copy off.
- Restart the box and watch the boot screen. The “copying log” message should be gone and the start-up back to its normal speed.
A TBox Ultra 3 owner whose every start began with “copying log” and a couple of minutes of delay turned the option off under Settings → Other and reported it stopped. An Ambient 6225 owner on the 15 Oct 2024 build, where the option had moved, found it in the box’s settings and turned it off as well.
Things to try (unverified)
- Look in the stock launcher’s own settings. One owner found the toggle, labelled Record log, inside the stock TBox launcher’s settings rather than the box’s Android settings. He reported finding it but not the result, so treat it as another place to look if the option is not where the steps above say.
- Remove the memory card. The log is copied to whatever card is inserted, so taking it out stops the message. Two owners were pointed to this; it costs you the card’s storage, so it is a workaround rather than the fix.
If nothing works
If the message stays after you turn the option off, note your box model and firmware date (Settings → About) and whether it still happens with no card inserted, then report it with how to report a bug.
This is a start-up log copy, not a firmware install. If your box instead stalls while updating firmware from a card, or the launcher does not open at boot, those are different problems.
What owners said
“Thanks, I really did switch it off!”
Owner, Carlinkit TBox Ultra 3, Aug 2026
“Found it, turned it off. Thanks a lot.”
Owner, Oct 2024
Quotes are translated where needed and shortened ([…]); names are removed. Full counts are in the evidence table below.
Questions owners ask
Will turning the log copy off break anything?
No. It only stops the box writing its diagnostic log to the card on each boot. Everything else, including installing firmware from a card, still works.
Where is the setting on my firmware?
It differs by build. On the TBox Ultra it is under Settings → Other → Automatic log copy; on the Ambient 6225 build from 15 Oct 2024 it moved, so look through the settings list. One owner also found a 'Record log' toggle in the stock launcher's own settings.
Can I just take the card out instead?
Yes. The log is copied to whatever card is inserted, so removing it stops the message. But then you lose the card's storage, so turning the setting off is the better fix.
Related fixes
- Launcher or App Doesn't Open When the Box StartsLow risk
- CarCar Launcher Laggy or Glitchy? Change the Rendering EngineLow risk
- AI Box Slow or Touch Off in CarPlay: 12 Owner ReportsLow risk
- Update TBox Firmware Locally With FOTA and a microSD CardAdvanced
- AI Box Too Bright at Night: Dark Theme That Stays DarkLow risk
Did this work for you?
Tell us which fix worked (or didn't), with your box, firmware date and car. Reports are how fixes get confirmed and re-ranked.
Send a reportChangelog
- Last reviewed against new community reports:
- Confirmed by 2 community reports on Carlinkit TBox Ultra 3, Carlinkit TBox Ambient.
- Page updated:
"Confirmed" means a community member reported that the fix worked on their unit. We have not tested it on our own hardware. How we verify.
Evidence behind these counts (1 case)
One row per case: a device, a symptom and a fix, merged from owner reports. An owner counts once per fix. Reports with no outcome yet are not counted. Forum and chat message references are kept on file but not published, to protect owners' privacy; public Reddit and YouTube sources are linked.
| Case | Confirmed on | Result | Source |
|---|---|---|---|
| case-9103 | Carlinkit TBox Ultra 3; Carlinkit TBox Ambient (2024-10-15) | 2 worked | Owner discussion threads, 6 messages |