Skip to content
AI Box Fix

TEYES head unitsReviewed

TEYES Does Not See a USB Flash Drive: Cable, Port, Format

TEYES head unit not detecting a USB flash drive? Unplug the car's factory USB lead from the unit, or replace the extension cable. CC3 2K, CC3L.

Illustration: TEYES CC3 2K glowing in a car dashboard at night

Quick answer

On a TEYES head unit that detects no USB flash drive on any socket, unplug the car's factory USB lead from the unit and use the unit's own extension lead: that brought USB back for 2 of 2 TEYES owners, one on a CC3 2K. Two more owners fixed a failed USB lead by replacing its extension cable.

Symptoms

  • No flash drive shows up on any of the unit's USB sockets, whichever drive you try
  • Reformatting the drive (FAT32, NTFS) or changing the USB 2.0 / 1.0 setting makes no difference
  • One USB lead works and the second one does not take a device
  • The unit reads a flash drive on some days and not on others
  • Plugging in a flash drive drops the dash cam, and the USB ports disappear until a restart

Applies to

Head unit
TEYES: CC3 2K, CC3L
Setup
Phone → TEYES unit
Phone projection
CarPlay and Android Auto
Highest risk on this page
Advanced
Status
Workaround confirmed by the community

Why it happens

The USB ports of a TEYES unit are leads plugged into the back of the unit. In one report they run to the glovebox, to the car’s factory USB socket and to a dash cam. Each lead is an extension cable with its own plug at the unit, and two leads on one unit are not always wired alike.

So a drive that is not detected has three places to fail before the unit’s software comes into it: the lead, whatever else is connected to the unit’s USB, and the drive. In the reports here the leads and the wiring were at fault more often than the drive. One owner changed drives, formats and the USB version setting with no result; his cause was the car’s factory USB lead, plugged into the unit next to its own.

A phone on wired CarPlay or Android Auto goes through the same leads and sockets. The checks on the lead and the socket are where to start for a phone that is not detected by cable too, but every report on this page is about flash drives or a dash cam: no owner here tested a fix with a phone. What owners did when the phone link itself would not come up is on TEYES CarPlay stuck on connecting.

Where is the fault?

Run these checks in order. Each one clears one device, so you only work on the part that fails.

One test per device in the chain between the phone and the car screen
CheckTry thisWhat it tells you
Flash driveTry a second drive, and open the first one on a computer.One owner tried every drive he had, and his fault turned out to be in the wiring. When several good drives fail alike, the drive is cleared.
Other USB devicesUnplug the dash cam, or anything else on the unit's USB leads, wait a moment and look in the file manager.One owner's drives came back after a short pause once the dash cam was unplugged and vanished when it went back in: the other device was holding the ports (see the third fix).
USB leadPlug the drive into each of the unit's USB leads in turn.If one lead reads the drive and another does not, the unit's USB works and that lead is where to look (second fix). A lead that shows 5 V is not cleared: one owner measured 5.2 V on a cable that had to be replaced.
Factory USB socketAsk the installer, or look behind the unit, whether the car's factory USB socket is wired to the unit.For two owners USB worked only after that lead was unplugged from the unit (first fix).
TEYES unitWith every other USB device unplugged, restart the unit and try one drive on each lead.If no lead reads any drive, what is left is the leads' plug at the back of the unit or the unit itself.

Not sure what an AI box would add to an Android head unit? See AI box or Android head unit.

Fixes, ranked

Unplug the car's factory USB lead from the unit

  • Advanced
  • Time: 30 minutes, or an installer visit
  • Worked for 2 of 2 TEYES owners

Warranty warning: this uses developer or engineering access. Follow the undo steps afterwards; some sellers refuse warranty claims on units with debugging left enabled.

  1. Find out whether the car’s factory USB socket was connected to the head unit when it was installed. If it was not, this fix does not apply.
  2. Switch the ignition off. Take the unit out of the dash far enough to reach the plugs at its back, or have the installer do it.
  3. Unplug the lead that runs to the car’s factory USB socket.
  4. Leave the unit’s own USB extension lead connected and refit the unit.
  5. Start the unit and plug the flash drive into the extension lead.

A CC3 2K owner had no working USB at all. He had checked the wiring, switched the USB setting from 2.0 to 1.0, tried every drive he had and formatted them as FAT32 and as NTFS. Nothing changed.

Another owner, with a unit in a Mazda CX-5, answered that he had the same at installation. The extension leads were replaced, and on his car the factory USB had to be disconnected: only then did the extension lead work. The first owner disconnected the factory USB and reported that everything worked.

The cost is the factory socket, which no longer reaches the unit. Neither owner said whether he got it working again later.

Replace the USB extension cable

  • Advanced
  • Time: 30 minutes, or an installer visit
  • Worked for 2 of 2 TEYES owners

Warranty warning: this uses developer or engineering access. Follow the undo steps afterwards; some sellers refuse warranty claims on units with debugging left enabled.

  1. Plug the drive into each USB lead in turn to find the one that fails.
  2. Switch the ignition off. Take the unit out of the dash far enough to reach the plugs at its back, or have the installer do it.
  3. Unplug the failing extension cable and look it over along its length.
  4. Fit a replacement extension cable made for your unit, from the seller or the installer.
  5. Refit the unit, start it and plug the drive in.

One owner, answering a CC3L owner whose unit did not see a flash drive, wrote that he had the same: he went to the installer, the cable was changed and everything worked. The CC3L owner has not reported a result yet.

A second owner was asking how to get a second USB device connected. He was advised to inspect the cable and to test with a multimeter for a break between the pins of its plug and the USB socket at its end. He measured 5.2 V at the end of the cable and found no visible break. He replaced the cable anyway, and everything worked.

So a healthy voltage and a clean-looking cable do not prove that it carries data. Neither owner named his model.

Put the dash cam on USB 1 and flash drives on USB 2

  • Low risk
  • Time: 10 minutes
  • Worked for 1 of 1 TEYES owner
  1. Find the unit’s two USB leads. One has more wires going into its plug than the other.
  2. Plug the dash cam into the lead with more wires, which is USB 1 on a CC3L.
  3. Plug flash drives into the other lead, USB 2.
  4. Restart the unit and check that the dash cam and the drive both stay connected.

A CC3L owner has two separate USB leads: USB 1 with many wires, USB 2 with fewer. He had put the dash cam on USB 2 by mistake. Each time he pushed a flash drive into USB 1 the dash cam dropped out and both ports vanished from the unit until he restarted it. With the dash cam on USB 1 and flash drives on USB 2 it has worked without a hitch.

He was answering a CC3 2K owner with a TEYES X5 dash cam and three USB ports. After the dash cam glitched, all three ports disappeared from the file manager. Unplugging the dash cam brought the drives back after a short pause; plugging it in again blocked them. His dash cam recovered after he powered it once from a cigarette-lighter USB adapter, and with it back on its old port the unit saw every port again. He asked what had happened and did not report anything further.

Format the flash drive as NTFS

  • Low risk
  • Time: 15 minutes
  • Worked for 1 of 2 TEYES owners
  1. Copy anything you need off the flash drive: formatting erases it.
  2. On a computer, format the drive as NTFS.
  3. Copy the files back, plug the drive into the unit and check that it is read.

A CC3L owner’s unit read a flash drive at some times and not at others, with three different drives. Another owner answered that formatting the drive as NTFS had helped him. He did not name his unit, and the CC3L owner has not reported a result yet.

It did not help the CC3 2K owner in the first fix, who formatted his drives as FAT32 and as NTFS before he found the wiring fault. Try it when the unit reads the drive some of the time. When no lead ever detects any drive, start with the leads.

Things to try (unverified on TEYES)

  • Change the USB version for the lead on the factory socket Advanced. An owner wrote that the single lead feeding the car’s factory socket sometimes needs USB 1.1 set in the unit’s factory settings. The one owner who reported changing the setting from 2.0 to 1.0 saw no change, and no TEYES owner reported that it worked.
  • Keep flash drives off the third USB port when a dash cam is connected. Suggested to the owner with three ports; no TEYES owner reported a result.
  • What AI box owners report. A USB device that an Android app does not detect has other causes on an AI box, and none of those reports are counted here: see AutoKit doesn’t see the USB adapter.

If nothing works

Write down the family (CC3, CC3L, CC3 2K and so on), the firmware version and the unit’s ID, which owners find under Settings → System. Add how many USB leads the unit has and what is on each, whether the car’s factory USB socket is wired in, the dash cam model if there is one, and the size and format of the drives you tried.

Take that to the installer first: two of the four fixes above are behind the unit. For the unit itself, contact the store you bought it from; the regional store’s support page is the official route. If no lead detects any drive with everything else unplugged and a new extension cable fitted, the fault may be in the unit’s USB hardware, and that is a warranty question for the seller.

What owners said

“There's 5.2 V at the end of the cable and no visible breaks. In the end I replaced the cable and everything worked.”
Worked: Replace the USB extension cable
Owner, Jul 2026
“I have a CC3L with two separate USB ports; USB 1 has many wires, USB 2 fewer. […] I connected the dash cam to USB 1 and plug flash drives into USB 2; now everything works without a hitch.”
Worked: Dash cam on USB 1, drives USB 2
Owner, TEYES CC3L, Jul 2025
“Thanks. I disconnected the factory USB and everything worked.”
Worked: Unplug the factory USB lead
Owner, TEYES CC3 2K, May 2025

Quotes are translated where needed and shortened ([…]); names are removed. Full counts are in the evidence table below.

Questions owners ask

The USB socket shows 5 V. Is the cable fine?

Not necessarily. One owner measured 5.2 V at the end of the extension cable and saw no damage on it, and USB still worked only after he replaced the cable.

Should the flash drive be FAT32 or NTFS?

The reports do not settle it. One owner's unit read his drive once it was formatted as NTFS. Another formatted his drives both ways with no change, because his fault was in the wiring behind the unit.

Which USB lead is for the dash cam?

On a CC3L, the owner who solved it put the dash cam on USB 1, the lead with more wires going into its plug, and uses USB 2 for flash drives.

Do these checks help a phone that is not detected by cable?

A phone on wired CarPlay or Android Auto uses the same leads, so the lead and socket checks are a sensible place to start. No report on this page tested a fix with a phone, so that is untested here.

Did this work for you?

Tell us which fix worked (or didn't), with your box, firmware date and car. Reports are how fixes get confirmed and re-ranked.

Send a report

Changelog

  • Last reviewed against new community reports:
  • Confirmed by 6 community reports on TEYES CC3 2K, TEYES CC3L, TEYES head unit (model not stated).
  • Page updated:

"Confirmed" means a community member reported that the fix worked on their unit. We have not tested it on our own hardware. How we verify.

Evidence behind these counts (4 cases)

One row per case: a device, a symptom and a fix, merged from owner reports. An owner counts once per fix. Reports with no outcome yet are not counted. Forum and chat message references are kept on file but not published, to protect owners' privacy; public Reddit and YouTube sources are linked.

CaseConfirmed onResultSource
case-1312TEYES CC3 2K; TEYES head unit (model not stated)2 workedOwner reviews, 3 messages
case-1313TEYES head unit (model not stated)2 workedOwner reviews, 5 messages
case-1314TEYES CC3L1 workedOwner reviews, 3 messages
case-1315TEYES head unit (model not stated)1 worked, 1 did notOwner reviews, 2 messages