TEYES head unitsReviewed
TEYES Reboots When You Start the Engine: USB Leads, Battery
TEYES head unit restarts at ignition-on or while the starter turns? Unplug the dashcam and drives from its USB leads, then test the battery under cranking.
TEYES head unit (model not stated)
Quick answer
On a TEYES head unit that reboots when the ignition goes on or the engine is cranked, unplug everything from its USB leads: one TEYES owner's reboots stopped once his dashcam power cable was off the lead. A new car battery ended them for a second owner, and a USB lead moved to its correct socket for a third.
Symptoms
- The TEYES unit restarts each time you switch the ignition on or crank the engine
- The unit is up and playing, and goes back to the logo as the starter turns
- The reboots began after a dashcam or a flash drive went onto one of the unit's USB leads
- The unit reboots, and switches itself on at odd moments, after a USB lead was fitted behind it
- The battery reads a normal voltage with the engine off
Applies to
- Head unit
- TEYES (owners did not name the model)
- Setup
- Phone → TEYES unit
- Phone projection
- CarPlay and Android Auto
- Highest risk on this page
- Advanced
- Status
- Workaround confirmed by the community
Why it happens
A TEYES unit takes its power from the car’s 12 V supply and feeds its own USB leads from it. The reports blame both ends. One owner’s unit restarted at ignition-on or engine start until a dashcam’s power cable came off one of those leads. Another’s began to reboot, and to switch itself on, once the lead for flash drives sat in the wrong socket behind the unit.
The third cause is the supply. Two owners say the unit switches itself off when its supply falls below about 11.8 V, and that a tired battery can dip that far for the moment the starter turns. The unit goes off, the alternator lifts the voltage, and the unit comes back with a full boot. Nobody posted a measurement, so 11.8 V is their figure and not a specification.
Whatever the cause, a restart drops the phone: CarPlay or Android Auto has to connect again once the unit is back (how to start CarPlay or Android Auto on a TEYES unit). None of the three owners tested his fix against a phone connection. If your unit was off while the car was parked and starts from zero where it should wake, that is not a restart: see TEYES cold boots at every engine start.
AI box owners trace most restarts to a USB port that cannot power the box (AI box keeps rebooting). A TEYES unit is wired to the car and is not fed from a USB port, so those reports prove nothing here. The page is linked as what AI box owners report, not as evidence.
Where is the fault?
Run these checks in order. Each one clears one device, so you only work on the part that fails.
| Check | Try this | What it tells you |
|---|---|---|
| When it restarts | With the ignition on and the unit fully up, start the engine and watch the screen. Then switch off, wait a minute and switch the ignition on without cranking. | A restart only while the starter turns fits the voltage dip two owners describe. A restart at ignition-on with no cranking does not, so what is plugged into the unit comes first. Nobody reported running this split; it follows from their description. |
| USB devices | Unplug every device from the unit's USB leads and make a day of short trips with many engine starts. | No reboot all day means one of the devices is the cause: first fix. One owner cleared his unit this way and traced it to the dashcam's power cable. |
| USB lead at the unit | Recall whether the reboots, or the unit switching itself on, began right after a USB lead was fitted or moved behind the unit. | If they did, the lead may sit in the wrong socket: third fix. One owner's unit behaved this way until the lead went where it belongs. |
| Car battery | Put a multimeter across the battery and have a helper crank the engine while you watch for the lowest reading, or ask a workshop for a load test. | A dip to about 11.8 V or lower fits what two owners describe. A resting reading clears nothing. No owner posted a cranking measurement, so this test comes from their description. |
Not sure what an AI box would add to an Android head unit? See AI box or Android head unit.
Fixes, ranked
Unplug everything from the unit's USB leads, then add back one by one
- Low risk
- Time: 10 minutes, then a day of driving
- Worked for 1 of 1 TEYES owner
- Unplug every device from the head unit’s USB leads: the dashcam power cable, flash drives, anything else.
- Make a day of short trips with repeated engine starts and watch for a reboot.
- If the reboots are gone, plug the devices back one at a time, with a day of starts between them.
- Leave unplugged the device that brings the reboots back.
One owner wrote up his own answer to a question he had asked earlier, adding that he saw many others with the same fault. His unit rebooted when the ignition went on or the engine started. On its external USB leads he had the power cable of a dashcam and a flash drive that recorded the rear-view camera.
He unplugged all of it and the reboots stopped. A whole day of short trips with constant engine starts passed cleanly. He then plugged the flash drive back in and everything stayed well, so he put the fault down to the dashcam.
He did not name his unit and did not say where the dashcam gets its power now. If the dashcam turns out to be your cause as well, it needs a feed that is not one of the unit’s USB leads, and that is a question for the installer. Which lead suits a dashcam that also sends its picture to the unit is a separate matter: a CC3L owner’s answer is on TEYES does not see a USB flash drive.
Replace a battery that sags while cranking
- Low risk
- Time: 1 hour with a workshop test
- Worked for 1 of 1 TEYES owner
- Measure the battery voltage while the starter turns, not at rest, or have a workshop load-test the battery.
- If the voltage dips to about 11.8 V or lower during cranking, replace the battery.
- Drive for a few days and watch for reboots at engine start.
One owner described this as his personal experience with reboots: when he bought a new battery, all of it went away at once. He was firm that it is no cure-all, only one of the causes, and he did not say at which moment his reboots used to come. Steps 1 and 2 are there so that you do not buy a battery on his word alone; they follow the two owners’ description and were not reported as a test.
The same owner later added that, by design as he understands it, the unit restarts by itself about every three days or every 50 wake-ups. An occasional full boot is therefore not a sign that the battery fix failed.
TEYES owners whose unit went off at starts also tried a setting, a 10-second delayed power-off. It helped one and changed nothing for another; those reports are on TEYES cold boots at every engine start.
Move the USB lead to its correct socket behind the unit
- Advanced
- Time: 30 minutes, or an installer visit
- Worked for 1 of 1 TEYES owner
Warranty warning: this uses developer or engineering access. Follow the undo steps afterwards; some sellers refuse warranty claims on units with debugging left enabled.
- Switch the ignition off. Take the unit out of the dash far enough to reach the plugs at its back, or have the installer do it.
- Photograph the plugs as they are.
- Compare where each USB lead is plugged in with the wiring diagram supplied with the unit, or ask the installer who fitted it, and move a lead that sits in the wrong socket to its own.
- Refit the unit, start it and watch for reboots over a day of driving.
One owner’s unit began to reboot once a flash drive was connected, and to switch itself on whenever it liked. It turned out that the lead for flash drives had been plugged into the wrong place, which he called a short circuit. He took the blame himself: with the lead where it belongs, everything worked.
He did not say which socket was the wrong one or which is right, and he did not name his unit; he was answering a CC3 2K owner. That is why step 3 sends you to the diagram or the installer and not to a socket number. Do not try sockets one after another: his own word for the wrong one was a short circuit.
If nothing works
Write down the family of the unit, its firmware version and the unit’s ID, which owners find under Settings → System. Add when the restart comes (at ignition-on, while cranking, or both), what is on each USB lead, the age of the battery and its lowest voltage during cranking. A short video of the screen across an engine start says more than a description, and how to report a bug lists what makes a report usable.
Take the wiring questions to the installer first, since two of the three fixes are about what is plugged into the unit. For the unit itself, contact the store you bought it from; the regional store has a support page. If it restarts with nothing on its USB leads and a battery that holds its voltage under cranking, the unit’s power lead or the unit is what remains, and that is a warranty question for the seller.
What owners said
“I had the dashcam power cable on one of the external USB leads […] I unplugged everything and the problem went away. Today I drove short trips all day with constant engine starts, and it works as it should.”
Owner, Jul 2024
“That's my personal experience with reboots. As soon as I bought a new battery, it all went away at once. […] Of course it's not a cure-all, it's just one instance of the problem.”
Owner, Apr 2024
“So it was my own fault: we plugged [the lead] in where it belongs and everything worked.”
Owner, Nov 2023
Quotes are translated where needed and shortened ([…]); names are removed. Full counts are in the evidence table below.
Questions owners ask
At what voltage does a TEYES unit switch itself off?
Two owners give about 11.8 V and describe it as a limit built into the unit. Neither posted a measurement and no TEYES document is quoted for it, so read it as their figure.
My battery shows a normal voltage. Can it still be the cause?
Yes, if you read it at rest. One member's example is a battery at 12.2 V that falls to 11.7 or 11.8 V while the starter turns. What counts is the lowest reading during cranking.
Can the flash drive go back in after the test?
It did for the owner who found the cause this way. He plugged his flash drive back in and the reboots stayed away, which is how he knew the dashcam's power cable was at fault.
The unit shows the logo at every start but was not running before. Is that this fault?
No. A unit that starts from zero where it should wake from sleep has other causes, mostly a shutdown setting or the SIM side. That is the related page on cold boots at every start.
Related fixes
- TEYES Cold Boots at Every Engine Start: Sleep Setting, SIMAdvanced
- AI Box Keeps Rebooting or Disconnecting? Start With PowerLow risk
- TEYES Does Not See a USB Flash Drive: Cable, Port, FormatAdvanced
- TEYES Android Auto Side Panel on the Wrong Side: Phone SettingLow risk
- TEYES Android Auto Not Connecting: Cable, 5 GHz, Blocked ListLow risk
Did this work for you?
Tell us which fix worked (or didn't), with your box, firmware date and car. Reports are how fixes get confirmed and re-ranked.
Send a reportChangelog
- Last reviewed against new community reports:
- Confirmed by 3 community reports on TEYES head unit (model not stated).
- Page updated:
"Confirmed" means a community member reported that the fix worked on their unit. We have not tested it on our own hardware. How we verify.
Evidence behind these counts (3 cases)
One row per case: a device, a symptom and a fix, merged from owner reports. An owner counts once per fix. Reports with no outcome yet are not counted. Forum and chat message references are kept on file but not published, to protect owners' privacy; public Reddit and YouTube sources are linked.
| Case | Confirmed on | Result | Source |
|---|---|---|---|
| case-1417 | TEYES head unit (model not stated) | 1 worked | Owner reviews, 1 message |
| case-1418 | TEYES head unit (model not stated) | 1 worked | Owner reviews, 3 messages |
| case-1419 | TEYES head unit (model not stated) | 1 worked | Owner reviews, 3 messages |